Blackstar Artisan 15 User Manual download pdf (Page 7)

1312

English

Rear Panel

1. Speaker Outputs

There are two parallel speaker outputs for connecting the internal speaker and/or

an external speaker cabinet. When connecting speakers always ensure that the

Impedance Selector (2) is set correctly.

2. Impedance Selector

This control matches the amplier’s impedance to that of the connected speakers.

Always ensure that the selected impedance matches that of the internal and/or

external speaker cabinets.

The Artisan 15’s internal speaker is 16 Ohms, so when used by itself the Impedance

Selector must be set to 16 Ohms. If an additional 16 Ohm speaker cabinet is used

together with the internal speaker the Impedance Selector should be set to 8 Ohms.

A speaker cabinet of less than 16 Ohms should not be used together with the

internal speaker.

WARNING: The amplier must always be completely powered down before

adjusting the setting of the Impedance Selector. Failure to do this, or to correctly

match the impedance of the amplier and speakers, will damage the amplier.

3. H.T. Fuse

The value of the H.T. Fuse is specied on the rear panel. Never use a fuse of the

incorrect value or attempt to bypass it.

4. Mains Fuse

The value of the Mains Fuse is specied on the rear panel. Never use a fuse of the

incorrect value or attempt to bypass it.

5. Mains Input

The supplied detachable mains lead is connected here. The lead should only

be connected to a power outlet that is compatible with the voltage, power and

frequency requirements stated on the rear panel. If in doubt get advice from a

qualied technician.

Technical Specication

Power (RMS): 15 Watts or 5 Watts (switchable)

Valves: 1 x EZ81, 2 x EL84, 2 x ECC83, 1 x EF86

Weight (kg): 23

Dimensions (mm): 617.5 x 544.5 x 234.5

12345

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

No comments

Blackstar Artisan 15 User Manual Page 7