Blackstar HT Stage 60 User Manual download pdf (Page 7)

1312

Technical Speciﬁcation

HT Stage 60

Power (RMS): 60 watts

Valves: 2 x EL34, 2 x ECC83, 1 x ECC82

Weight (kg): 30.3

Dimensions (mm): 715 x 586 x 278

Footswitch: FS-7 included, optional FS-4 for Overdrive 2 Voice

HT Stage 100

Power (RMS): 100 watts

Valves: 4 x EL34, 2 x ECC83, 1 x ECC82

Weight (kg): 21.3

Dimensions (mm): 670 x 313 x 263

Footswitch: FS-7 included, optional FS-4 for Overdrive 2 Voice

5. Speaker Emulated Output

This output emulates the tonal characteristics of a guitar speaker cabinet and

provides a natural valve overdrive tone for connection to a recording device or

mixing desk. Always use a good quality screened lead.

NOTE: To ‘silently’ record, turn the amp to standby mode. You may also record

from this output while in standby mode without a loudspeaker connected, but

ensure that no loudspeaker leads are connected to any of the loudspeaker output

jack sockets of the amplier, as this will defeat the load protection circuit and cause

damage to the amplier.

6. Cabinet Switch

The switch enables you to select either a 4x12 closed back or a 1x12 open back

cabinet emulation for the Speaker Emulated Output.

7. Reverb Dark/Light

In the out position the digital reverb is voiced to have a warm dark quality. When

the Light position is selected the reverb has a brighter quality with more zing on the

reverb tail.

8. Effects Loop Return

Connect the (mono) output of an external effects unit here.

9. Effects Loop Send

Connect the (mono) input of an external effects unit here.

10. Effects Loop Level

The Effects Loop Level switch sets the effects loop to either +4dBV/-10dBV, which

enables you to use it with either professional equipment (+4dBV setting), or with

guitar level effects such as effects pedals (-10dBV setting).

11. Overdrive 2 Voice Footswitch

An optional 1-way latching footswitch (Blackstar FS-4 recommended) may be

connected here to allow the Overdrive 2 Voice function to be remotely controlled.

12. Footswitch

The supplied footswitch is connected here. The footswitch enables you to switch

between Clean, Overdrive 1 and Overdrive 2, and Reverb on/off.

English

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

Comments to this Manuals

No comments

Blackstar HT Stage 60 User Manual Page 7

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Blackstar HT Stage 60