Blackstar ID:CORE STEREO 10 Owner's Manual download pdf (Page 6)

8. REV (Reverb)

Press this switch to turn the stereo reverb effect on, off, or focus the effect for

editing. This setting is saved when you store a patch.

For all three effect switches/buttons, the LED shows what state the effect is in:

LED Eect State Description

LED not on Eect o Eect not active

LED red Eect on but not ‘focused’ for editing Eect is active, but not aected by the front

panel eect controls

LED green Eect on and ‘focused’ for editing Eect active and aected by the front panel

eect controls

Repeatedly pressing each effect switches on the front panel has the following effect:

Current Eect State Next Eect State

Eect o Turns the eect on and ‘focuses’ the eect. Any previously focused eect

reverts to an ‘on’ state

Eect on but not ‘focused’ Focuses the eect. Any previously focused eect reverts to an ‘on’ state

Eect on and ‘focused’ Turns the eect o. If any other eect(s) are on, the previously ‘focused’ eect

resumes being ‘focused’

NOTE: Only one effect may be ‘focused’ at any time.

9. Effect Type

This changes the effect type and edits a parameter of the currently ‘focused’ effect

(modulation, delay, or reverb).

Each segment represents a different effect (four for each type of effect). An

LED shows which effect type is currently active. The distance travelled through

the ‘segment’ modifies an effect parameter. The Effects Table below shows the

modifiable parameters.

This setting is saved when you store a patch.

10. Effect Level

This modifies an effect parameter. For modulation and delay effects, turning the Level

control while holding down the Tap button (11) modifies the rate/time of the effect.

The Effects Table below shows the modifiable parameters.

This setting is saved when you store a patch.

English

11. Tap

The Tap switch is used to set the rate/time of the current ‘focused’ effect. The time

between each press of the tap button defines the rate set.

Once set, the Tap LED will flash in time with the set rate of the currently ‘focused’

effect.

The Effects Table below shows the modifiable parameters:

Effects Table

Eect Segment Parameter Level Parameter Tap Parameter

MODULATION

Phaser Mix Depth Speed

Flanger Feedback Depth Speed

Chorus Mix Depth Speed

Tremolo Frequency modulation depth Amplitude modulation depth Speed

DELAY

Linear Feedback Delay level Time

Analogue Feedback Delay level Time

Tape Feedback Delay level Time

Multi Feedback Delay level Time

REVERB

Room Size Reverb level -

Hall Size Reverb level -

Spring Size Reverb level -

Plate Size Reverb level -

This setting is saved when you store a patch.

12. Power Switch

This switch is used to turn the amplifier on and off; the white dot marks the ON

position.

13. USB

Plug a USB cable in here to connect the amplifier to a Windows PC or Mac.

Blackstar’s INSIDER software offers a host of features and can be downloaded

from: www.blackstarinsider.co.uk

See the USB Audio section on page 15 for more information.

NOTE: The amplifier will appear on a personal computer as an audio capture device

within recording software.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Comments to this Manuals

No comments

Blackstar ID:CORE STEREO 10 Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for Audio amplifiers Blackstar ID:CORE STEREO 10